We have a very limited number of 1911 slides in, These are from a major manufacture and have the features listed below. We just assembled a couple of these and of note they have very tight rails for those of you who like to match them to your slides. All features work great and are the way they should be. The reason for the lower cost, is the parkerized finish is not good. These are blemish units due to the finish(they are more like a military parkerization), they can be redone and we may send some in for Boron Nickle-if you would like some of those, please let us know. There are no manufactures marks on them. After assembling ours, we love the angled double serration grips on the side, its looks bad ass compared to what was previously on the frame.
Details of the slides for the 1911A1 .45 ACP pistol. This full length slide is made from 4140 Chrome moly steel and is hardened to Rc 44-46 throughout for a lifetime of service. This slide is machined to the Mil Spec for mating parts so any mil spec parts or series 70 frames will fit. The slide has both front and rear cocking serrations, a lowered and flared ejection port for positive ejection, the rear is machined for standard pattern adjustable sights (.330 x 60 degree x 110″ with .500 flat forward and .258 to the rear cut. Bottom of dovetail to top of slide is .138″ These were made for a special LPA sight. This is about .012″ (about 3 sheets of paper) narrower than some rear sights so some fitting may be required for a nice tight fit. The front is machined for a standard dovetail front sight. .330″ x 65 degree x .060 dovetail. Center of front dovetail to front of slide .325″. Parkerized finish.
Please note, we will not have any shipping the week of August 4th as we are on vacation.